IEC 60335-1 Power Cord Flexibility Test Equipment For Household
Appliances PLC Controlled
Product information:
Standard: Clause 25.14 of IEC 60335-1 Household and similar
electrical appliances – Safety – Part 1: General requirements.
Application: It is used to check that the supply cord of the small
household appliances (such as Coffee pot / electric iron) and lamps
is adequately protected against excessive flexing where it enters
the appliance.
Test sample: Small household appliances, such as coffee pot,
electric iron, toaster, luminaires and etc.
Feature: The test stations, test angles, load voltage can be
customized. The test cycles, speed, voltage, etc., can be preset.
Technical parameters:
| Input Power | AC220V, 50Hz |
| Control Method | PLC control, touch screen operation |
| Station | One |
| Drive Mode | Electrical |
| Flexing Angle | 0-360°, preset on the touch screen |
| Flexing Speed | 0-60 cycles/min, can be preset |
| Test Cycles | 0-999999, can be preset |
| Loading Weight | 5N,10N |
| Loading Voltage | 0-250V, can be regulated |
| Sample judgment | Judge the conduction by current |
Structure
Maintenance
Before testing, please check the components of the fixture is loose
or not.
Before testing, please check whether the load socket is damaged or
not.
Before testing, please check whether the manipulator swivel smooth
by operate the manually speed.
Under non-work state, please take off the test samples and weights,
turn off the load power supply and external power supply.
Please do not place any heavy and sharp objects on the equipment.
Please do not thrust the machine components, in order to avoid
position offsetting.
Please keep away from liquid, in order to avoid electrical circuit
short.
Special function
【Single/Double sieded】selected button: Operator can select one side
which is with 0° as the center line to do reciprocating flexing
(Single-Sided swivel) in this system, and the reciprocating swing
range will not exceed the center line. Operator can also select
each half flexing angle of the left and right direction around the
center line at 0°, that is, flex around the center line
(reciprocating) (Double -Sided swivel). The default is double-sided
flexing. Press the button for single-sided swivel. This button can
be used in conjunction with the [Left and Right Swivel] button to
select the direction and single-side and double-side swivel at the
same time. Special note: Before switching of these buttons,
operator must make sure that the turntable is at the starting
position by pressing [Homing] button, and the counts are cleared by
pressing [Count Cleared] button, then the switching of these
buttons will be effective. The purpose is to avoid changing the
direction of rotation while one direction is being tested.
