10KN Tensile Strength Test Machine With Computer Control Tensile
Strength And Deformation Test
Product information:
This machine adopts computer control, widely used in the mechanical
properties of various materials test, with special fixture is also
suitable for all kinds of finished products tensile, compression,
stripping, shear, tear, bending (folding) test. It can print a
number of data, according to different data to make graphic output
comparison, high control precision, easy to operate; Modular
design, a variety of accessories variety, flexible collocation.
Control software introduction:
1.Software operating system language: English.
2. Force value unit: N, KN, Kgf, Lbf
3. Length unit: mm, cm, inch can be freely converted
4. Control mode: computer software to set speed, set load break
(rupture), running time and other control modes
5. Type of curve: load-displacement, load-time, displacement-time.
Stress-strain, strain-time, stress-time. The vertical and
horizontal coordinates of the curve can be set arbitrarily.
Technical parameters:
1. Test strength range: 0-10KN, 0-500N double channel sensor
2. Force measurement accuracy: 0.001Kg
3. Switch units: Kg, N, Lb
4. Load analysis: 1/250000
5. Load accuracy: ±0.5%
6. Force measurement display accuracy: 0.001Kg
7. Displacement measurement display accuracy: 0.001mm
8. Equipped with: large deformation extensometer
9. The machine has two-level control buttons for emergency stop,
fast and slow up and down movement, which can be operated through
software and control unit
10. Deformation measurement range: 0.2%-100%FS
11. Test stroke: 900mm (including fixture)
12. Test effective width: 400mm
13. Speed test range: 0.001-1000mm/min stepless speed regulation
14. Transmission system: using servo motor, Taiwan ZPT ball screw,
computer software TM2101
15. Safety device: overload emergency stop device, up and down
travel limit device, automatic breakpoint stop function
Computer configuration: new laptop compatible with Windows 11,
equipped with at least Intel i7 or equivalent processor.
16. Test fixtures:
- 10 kN capacity mechanical wedge-type tensile grip set with
interchangeable jaws capable of gripping flat specimens with a
thickness between 0 and 12 mm and cylindrical specimens with a
diameter between 4 and 12 mm, equipped with V-jaw inserts.
- 5 kN capacity side-acting grip set with interchangeable jaws.
- 10 kN capacity compression grip set with a minimum upper
diameter of Ø120 mm and a lower diameter of at least Ø200 mm. The
upper compression grip must have a spherical free form for
centering.
- Three-point bending test set according to ISO 178 with an
adjustable lower support between 10 and 180 mm and a 5 mm radius
lower support and bending tip.
17. Working power: AC220V 50HZ
18. Working power: 1.0KW
19. Machine weight: about 150kg
Working conditions of the testing machine:
1. In the range of room temperature 10℃-35℃, the relative humidity
is not more than 80%;
2. Install correctly on a solid foundation or workbench;
3. In a vibration-free environment, leave no less than 1m space
around;
4. No corrosive media around;
5. The fluctuation range of the power supply voltage should not
exceed 10% of the rated voltage.
Configuration list:
| 1. Testing machine host | A Set |
| 2. Servo motor | A Set |
| 3.High quality and high precision load sensor | Two PC |
| 4. Deceleration system | A Set |
| 5. Taiwan ZPT ball screw | A Set |
| 6. Fixtures | A Set |
| 7. Large deformation measurement system | A Set |
| 8. TM2101 measurement software | A Set |
